Ipv6; Ipv6 Address - HP E4510-48G Command Reference Manual

ipv6

Syntax
ipv6
undo ipv6
View
System view
Default Level
2: System level
Parameters
None
Description
Use the ipv6 command to enable IPv6.
Use the undo ipv6 command to disable IPv6.
By default, IPv6 is disabled.
Examples
# Enable IPv6.
<Sysname> system-view
[Sysname] ipv6

ipv6 address

Syntax
ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }
undo ipv6 address [ ipv6-address prefix-length | ipv6-address/prefix-length ]
View
Interface view
Default Level
2: System level
Parameters
ipv6-address: IPv6 address.
prefix-length: Prefix length of the IPv6 address, in the range 1 to 128.
Description
Use the ipv6 address command to configure an IPv6 site-local address or aggregatable global unicast
address for an interface.
Use the undo ipv6 address command to remove the IPv6 address from the interface.
12-23