Display Ripng Route - HP E4510-48G Command Reference Manual

Field
Default route
Summary address

display ripng route

Syntax
display ripng process-id route
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535.
Description
Use the display ripng route command to display all RIPng routes and timers associated with each
route of a RIPng process.
Examples
# Display the routing information of RIPng process 100.
<Sysname> display ripng 100 route
Route Flags: A - Aging, S - Suppressed, G - Garbage-collect
----------------------------------------------------------------
Peer FE80::200:5EFF:FE04:B602 on Vlan-interface100
Dest 3FFE:C00:C18:1::/64,
via FE80::200:5EFF:FE04:B602, cost 2, tag 0, A, 34 Sec
Dest 3FFE:C00:C18:2::/64,
via FE80::200:5EFF:FE04:B602, cost 2, tag 0, A, 34 Sec
Only/Originate: Only means that the interface advertises only the default
route. Originate means that the default route and other RIPng routes are
advertised.
Off indicates that no default route is advertised or the garbage-collect time
expires after the default route advertisement was disabled.
In garbage-collect status: With default route advertisement disabled, the
interface advertises the default route with metric 16 during the
garbage-collect time.
The summarized IPv6 prefix and the summary IPv6 prefix on the interface
5-6
Description