Dldp Delaydown-Timer; Dldp Enable - HP E4510-48G Command Reference Manual

Examples
# Configure to perform plain text authentication, setting the password as abc (assuming that Device A
and Device B are connected by the DLDP link).
Configuration on Device A
<DeviceA> system-view
[DeviceA] dldp authentication-mode simple abc
Configuration on Device B
<DeviceB> system-view
[DeviceB] dldp authentication-mode simple abc

dldp delaydown-timer

Syntax
dldp delaydown-timer time
undo dldp delaydown-timer
View
System view
Default Level
2: System level
Parameters
Time: Setting of the DelayDown timer, in the range 1 to 5 (in seconds).
Description
Use the dldp delaydown-timer command to set the DelayDown timer.
Use the undo dldp delaydown-timer command to restore the default.
By default, the setting of the DelayDown timer is 1 second.
Note that the DelayDown timer configured using this command applies to all DLDP-enabled ports.
Examples
# Set the DelayDown timer to 2 seconds.
<Sysname> system-view
[Sysname] dldp delaydown-timer 2

dldp enable

Syntax
dldp enable
undo dldp enable
View
System view, Ethernet port view, port group view
4-5