Port Smart-Link Group - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
interface-type interface-number: Port type and port number.
master: Specifies a port as the master port.
slave: Specifies a port as the slave port.
Description
Use the port command to assign the specified port as the master or slave port of the current smart link
group.
Use the undo port command to remove the specified port from the smart link group.
Note that:
Disable STP and RRPP on the ports you want to add to the smart link group, and make sure that
the ports are not member ports of any aggregation group or service loopback group. On the other
hand, you cannot enable STP or RRPP on a smart link group member port or assign a smart link
group member port to an aggregation group or service loopback group.
You can assign a port to a smart link group with the port smart-link group command in Ethernet
interface view or Layer-2 aggregate interface view.
Related commands: port smart-link group.
Examples
# Configure GigabitEthernet 1/0/1 as the slave port of smart link group 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] undo stp enable
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] smart-link group 1
[Sysname-smlk-group1] protected-vlan reference-instance 0
[Sysname-smlk-group1] port gigabitethernet 1/0/1 slave

port smart-link group

Syntax
port smart-link group group-id { master | slave }
undo port smart-link group group-id
View
Ethernet interface view, Layer-2 aggregate interface view
Default Level
2: System level
Parameters
group-id: Smart link group ID. The minimum value is 1, while the maximum value is 26.
1-4