Display User-Interface - HP E4510-48G Command Reference Manual

Description
Use the display telnet client configuration command to display the source IP address or source
interface configured for the current device.
Example
# Display the source IP address or source interface configured for the current device.
<Sysname> display telnet client configuration
The source IP address is 1.1.1.1.

display user-interface

Syntax
display user-interface [ type number | number ] [ summary ]
View
Any view
Default Level
1: Monitor level
Parameters
type: User interface type.
number: Absolute or relative index of the user interface. This argument can be an absolute user
interface index (if you do not provide the type argument) or a relative user interface index (if you
provide the type argument).
summary: Displays the summary information about a user interface.
Description
Use the display user-interface command to view information about the specified or all user
interfaces.
When the summary keyword is absent, the command will display the type of the user interface, the
absolute or relative number, the speed, the user privilege level, the authentication mode and the
physical location.
When the summary keyword is present, the command will display all the number and type of user
interfaces under use and without use.
Examples
# Display the information about user interface 0.
<Sysname> display user-interface 0
Idx Type
F 0 AUX 0
+ : Current user-interface is active.
F : Current user-interface is active and work in async mode.
Idx : Absolute index of user-interface.
Type : Type and relative index of user-interface.
Tx/Rx Modem Privi Auth Int
19200 - 3 N -
1-7