Mld-Snooping Querier - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
vlan vlan-list: Defines one or multiple VLANs. You can provide up to 10 VLAN lists, by each of which
you can specify an individual VLAN in the form of vlan-id, or a VLAN range in the form of start-vlan-id
to end-vlan-id, where the end VLAN ID must be greater than the start VLAN ID. The effective range of
a VLAN ID is 1 to 4094.
Description
Use the mld-snooping overflow-replace command to enable the IPv6 multicast group replacement
function on the current port(s).
Use the undo mld-snooping overflow-replace command to disable the IPv6 multicast group
replacement function on the current port(s).
By default, the IPv6 multicast group replacement function is disabled.
Note that:
This command works on MLD Snooping–enabled VLANs.
If you do not specify any VLAN when using this command in Ethernet port view or Layer 2
aggregate port view, the command will take effect for all VLANs the port belongs to; if you specify
a VLAN or multiple VLANs, the command will take effect only if the port belongs to the specified
VLAN(s).
If you do not specify any VLAN when using this command in port group view, the command will
take effect on all the ports in this group; if you specify a VLAN or multiple VLANs, the command
will take effect only on those ports in this group that belong to the specified VLAN(s).
Related commands: overflow-replace.
Examples
# Enable the IPv6 multicast group replacement function on GigabitEthernet 1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitgthernet 1/0/1
[Sysname- GigabitEthernet 1/0/1] mld-snooping overflow-replace vlan 2

mld-snooping querier

Syntax
mld-snooping querier
undo mld-snooping querier
View
VLAN view
Default Level
2: System level
3-16