Ipv6 Nd Hop-Limit - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
value: Number of attempts to send an NS message for DAD, in the range of 0 to 600. The default value
is "1". When it is set to 0, DAD is disabled.
Description
Use the ipv6 nd dad attempts command to configure the number of attempts to send an NS message
for DAD.
Use the undo ipv6 nd dad attempts command to restore the default.
By default, the number of attempts to send an NS message for DAD is 1.
Related commands: display ipv6 interface.
Examples
# Set the number of attempts to send an NS message for DAD to 20.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd dad attempts 20

ipv6 nd hop-limit

Syntax
ipv6 nd hop-limit value
undo ipv6 nd hop-limit
View
System view
Default Level
2: System level
Parameters
value: Number of hops, in the range of 0 to 255. When it is set to 0, the Hop Limit field in RA messages
sent by the device is 0. That is, the number of hops is determined by the requesting device itself.
Description
Use the ipv6 nd hop-limit command to configure the hop limit advertised by the device.
Use the undo ipv6 nd hop-limit command to restore the default hop limit.
By default, the hop limit advertised by the device is 64.
Examples
# Set the hop limit advertised by the device to 100.
<Sysname> system-view
[Sysname] ipv6 nd hop-limit 100
12-31