Igmp-Snooping General-Query Source-Ip; Igmp-Snooping Group-Limit - HP E4510-48G Command Reference Manual

Examples
# Enable fast leave processing on GigabitEthernet1/0/1 in VLAN 2.
<Sysname> system-view
[Sysname] interface gigabitethernet1/0/1
[Sysname-GigabitEthernet1/0/1] igmp-snooping fast-leave vlan 2

igmp-snooping general-query source-ip

Syntax
igmp-snooping general-query source-ip { current-interface | ip-address }
undo igmp-snooping general-query source-ip
View
VLAN view
Default Level
2: System level
Parameters
current-interface: Sets the source address of IGMP general queries to the address of the current
VLAN interface. If the current VLAN interface does not have an IP address, the default IP address
0.0.0.0 will be used as the source IP address of IGMP general queries.
ip-address: Specifies the source address of IGMP general queries, which can be any legal IP address.
Description
Use the igmp-snooping general-query source-ip command to configure the source address of
IGMP general queries.
Use the undo igmp-snooping general-query source-ip command to restore the default
configuration.
By default, the source IP address of IGMP general queries is 0.0.0.0.
This command takes effect only if IGMP Snooping is enabled in the VLAN.
Examples
# In VLAN 2 specify 10.1.1.1 as the source IP address of IGMP general queries.
<Sysname> system-view
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping general-query source-ip 10.1.1.1

igmp-snooping group-limit

Syntax
igmp-snooping group-limit limit [ vlan vlan-list ]
undo igmp-snooping group-limit [ vlan vlan-list ]
1-9