Probe Timeout - HP E4510-48G Command Reference Manual

Parameters
packet-timeout: Timeout time for waiting for responses in a UDP jitter or voice test, in the range 10 to
3600000 milliseconds.
Description
Use the probe packet-timeout command to configure the timeout time for waiting for responses in a
UDP jitter or voice test.
Use the undo probe packet-timeout command to restore the default.
By default, the timeout time in a UDP jitter and a voice test is 3000 and 5000 milliseconds respectively.
Examples
# Configure the timeout time for waiting for responses in a UDP jitter test as 100 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type udp-jitter
[Syaname-nqa-admin-test-udp-jitter] probe packet-timeout 100

probe timeout

Syntax
probe timeout timeout
undo probe timeout
View
DHCP, DLSw, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo test type view
Default Level
2: System level
Parameters
timeout: Timeout time in a probe except UDP jitter probe, in milliseconds. For an FTP or HTTP probe,
the value range is 10 to 86400000; for a DHCP, DLSw, ICMP echo, SNMP, TCP or UDP echo probe,
the value range is 10 to 3600000.
Description
Use the probe timeout command to configure the timeout time in a probe.
Use the undo probe timeout command to restore the default.
By default, the timeout time is 3000 milliseconds.
After an NQA probe begins, if the NQA probe is not finished within the time specified in the probe
timeout command, then the probe times out.
Examples
# Configure the timeout time in a DHCP probe as 10000 milliseconds.
<Sysname> system-view
[Sysname] nqa entry admin test
18-27