Sflow Collector Ip; Sflow Enable - HP E4510-48G Command Reference Manual

sFlow does not work if the sFlow agent has no IP address configured, or the IP address of the
sFlow agent is removed.
Examples
# Configure the IP address of the sFlow agent.
<Sysname> system-view
[Sysname] sflow agent ip 10.10.10.1

sflow collector ip

Syntax
sflow collector ip ip-address [ port portnum ]
undo sflow collector ip ip-address
View
System view
Default Level
2: System level
Parameters
ip-address: IP address of the sFlow collector.
port portnum: Port number of the sFlow Collector, which is in the range 1 to 65535 and defaults to
6343.
Description
Use the sflow collector ip command to specify the IP address and port number of an sFlow collector.
Use the undo sflow collector ip command to remove an sFlow collector.
By default, no sFlow collector is specified.
Note that:
The sFlow collector and sFlow agent must not have the same IP address.
Currently, you can specify at most two sFlow collectors, with one as the backup sFlow collector.
sFlow does not work if no sFlow collector is specified.
If only one sFlow collector is specified, sFlow does not work after you use the undo sflow
collector ip command to disable it.
Examples
# Specify the IP address and port number of an sFlow collector.
<Sysname> system-view
[Sysname] sflow collector ip 10.10.10.2 port 6343

sflow enable

Syntax
sflow enable { inbound | outbound }
13-3