Statistics Interval - HP E4510-48G Command Reference Manual

When the number of statistics groups kept reaches the upper limit, if a new statistics group is
generated, the statistics group that is kept the longest is deleted.
Note that:
This command is supported in all tests except DHCP tests.
The value of 0 indicates that no statistics are collected.
Examples
# Configure the maximum number of statistics groups that can be kept as 5.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] statistics max-group 5

statistics interval

Syntax
statistics interval interval
undo statistics interval
View
DLSw, FTP, HTTP, ICMP echo, SNMP, TCP, UDP echo, UDP jitter, voice test type view
Default Levels
2: System level
Parameters
interval: Interval for collecting statistics of the test results in minutes, in the range 1 to 35791394.
Description
Use the statistics interval command to configure the interval for collecting statistics of the test results.
Use the undo statistics interval command to restore the default.
By default, the interval is 60 minutes.
NQA puts the NQA tests completed in a certain interval into one group, and calculates the statistics of
the test results of the group. These statistics form a statistics group. You can use the display nqa
statistics command to display information of the statistics group.
Note that this command is supported on all types of tests except DHCP tests.
Examples
# Configure the interval for collecting statistics of the test results as 2 minutes.
<Sysname> system-view
[Sysname] nqa entry admin test
[Sysname-nqa-admin-test] type icmp-echo
[Sysname-nqa-admin-test-icmp-echo] statistics interval 2
18-34