Rrpp Enable - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
domain-id: RRPP domain ID, in the range 1 to 8.
Description
Use the rrpp domain command to create an RRPP domain and enter its view.
Use the undo rrpp domain command to remove an RRPP domain.
Note that:
When you delete an RRPP domain, the control VLANs and protected VLANs of it are deleted at
the same time.
To delete an RRPP domain successfully, be sure that it has no RRPP rings.
Related commands: control-vlan, protected-vlan.
Examples
# Create RRPP domain 1, and enter RRPP domain 1 view.
<Sysname> system-view
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1]

rrpp enable

Syntax
rrpp enable
undo rrpp enable
View
System view
Default Level
2: System level
Parameters
None
Description
Use the rrpp enable command to enable RRPP protocol.
Use the undo rrpp enable command to disable RRPP protocol.
By default, RRPP protocol is disabled.
To activate the RRPP domain, enable the RRPP protocol and the RRPP rings for the RRPP domain.
Related commands: ring enable.
3-16