Secondary Authentication (Radius Scheme View) - HP E4510-48G Command Reference Manual

View
RADIUS scheme view
Default Level
2: System level
Parameters
ip-address: IP address of the secondary accounting server, in dotted decimal notation. The default is
0.0.0.0.
port-number: UDP port number of the secondary accounting server, which ranges from 1 to 65535 and
defaults to 1813.
Description
Use the secondary accounting command to specify the secondary RADIUS accounting server.
Use the undo secondary accounting command to remove the configuration.
By default, no secondary RADIUS accounting server is specified.
Note that:
The IP addresses of the primary and secondary accounting servers cannot be the same.
Otherwise, the configuration fails.
The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: key, radius scheme, state.
Examples
# Specify the secondary accounting server for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] secondary accounting 10.110.1.1 1813

secondary authentication (RADIUS scheme view)

Syntax
secondary authentication ip-address [ port-number ]
undo secondary authentication
View
RADIUS scheme view
Default Level
2: System level
2-19