Ntdp Timer; Ntdp Timer Hop-Delay - HP E4510-48G Command Reference Manual

ntdp timer

Syntax
ntdp timer interval-time
undo ntdp timer
View
System view
Default Level
2: System level
Parameters
interval-time: Interval (in minutes) to collect topology information, in the range 0 to 65,535. The value 0
means not to collect topology information.
Description
Use the ntdp timer command to configure the interval to collect topology information.
Use the undo ntdp timer command to restore the default.
By default, the interval to collect topology information is 1 minute.
Note that the management device can start to collect the topology information only after the cluster is
set up.
Examples
# Set the interval to collect the topology information to 30 minutes.
<Sysname> system-view
[Sysname] ntdp timer 30

ntdp timer hop-delay

Syntax
ntdp timer hop-delay time
undo ntdp timer hop-delay
View
System view
Default Level
2: System level
Parameters
time: Delay time (in milliseconds) for a device receiving topology-collection requests to forward them
through its first port. This argument ranges from 1 to 1,000.
20-13