Open Ipv - HP E4510-48G Command Reference Manual

Description
Use the open command to log in to the IPv4 FTP server under FTP client view.
At login, you will be asked to enter the username and password for accessing the FTP server. If your
input is correct, the login succeeds; otherwise, it fails.
If you have logged in to the IPv4 FTP server currently, you cannot use the open command to log in to
another server. You need to disconnect with the current server first, and then try to connect with
another one.
Related commands: close.
Examples
# In FTP client view, log in to the FTP server with the IP address of 192.168.1.50.
<Sysname> ftp
[ftp] open 192.168.1.50
Trying 192.168.1.50 ...
Press CTRL+K to abort
Connected to 192.168.1.50.
220 FTP service ready.
User(192.168.1.50:(none)):aa
331 Password required for aa.
Password:
230 User logged in.
[ftp]

open ipv6

Syntax
open ipv6 server-address [ service-port ] [ -i interface-type interface-number ]
View
FTP client view
Default Level
3: Manage level
Parameters
server-address: IP address or host name of the remote FTP server.
service-port: Port number of the remote FTP server, in the range 0 to 65535. The default value is 21.
-i interface-type interface-number: Specifies the egress interface by its type and number. This
parameter can be used only in case that the FTP server address is a link local address and the
specified egress interface must have a link local address (For the configuration of link local addresses,
see IPv6 Basics in the IP Services Volume).
Description
Use the open ipv6 command to log in to the IPv6 FTP server in FTP client view.
6-21