Ripng - HP E4510-48G Command Reference Manual

Use the undo preference route-policy command to restore the default.
By default, the priority of a RIPng route is 100.
Using the route-policy keyword can set a priority for routes filtered in by the routing policy:
If a priority is set in the routing policy, the priority applies to matched routes, and the priority set by
the preference command applies to routes not matched.
If no priority is set in the routing policy, the one set by the preference command applies to all
routes.
Examples
# Set the RIPng route priority to 120.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100] preference 120
# Restore the default RIPng route priority.
[Sysname-ripng-100] undo preference

ripng

Syntax
ripng [ process-id ]
undo ripng [ process-id ]
View
System view
Default Level
2: System level
Parameters
process-id: RIPng process ID, in the range of 1 to 65535. The default value is 1.
Description
Use the ripng command to create a RIPng process and enter RIPng view.
Use the undo ripng command to disable a RIPng process.
By default, no RIPng process is enabled.
Examples
# Create RIPng process 100 and enter its view.
<Sysname> system-view
[Sysname] ripng 100
[Sysname-ripng-100]
# Disable RIPng process 100.
[Sysname] undo ripng 100
5-10