Rip; Rip Authentication-Mode - HP E4510-48G Command Reference Manual

Examples
# Clear statistics in RIP process 100.
<Sysname> reset rip 100 statistics

rip

Syntax
rip [ process-id ]
undo rip [ process-id ]
View
System view
Default Level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535. The default is 1.
Description
Use the rip command to create a RIP process and enter RIP view.
Use the undo rip command to disable a RIP process.
By default, no RIP process runs.
Note that:
You must enable the RIP process before configuring the global parameters. This limitation is not
for configuration of interface parameters.
The configured interface parameters become invalid after you disable the RIP process.
Examples
# Create a RIP process and enter RIP process view.
<Sysname> system-view
[Sysname] rip
[Sysname-rip-1]

rip authentication-mode

Syntax
rip authentication-mode { md5 { rfc2082 key-string key-id | rfc2453 key-string } | simple password }
undo rip authentication-mode
View
Interface view
Default Level
2: System level
3-16