Cluster-Snmp-Agent Group V - HP E4510-48G Command Reference Manual

# Configure the SNMP community name shared by a cluster as comaccesswr and allow the
community's read-write access to MIB objects.
[aaa_0.Sysname-cluster] cluster-snmp-agent community write comacceswr

cluster-snmp-agent group v3

Syntax
cluster-snmp-agent group v3 group-name [ authentication | privacy ] [ read-view read-view ]
[ write-view write-view ] [ notify-view notify-view ]
undo cluster-snmp-agent group v3 group-name [ authentication | privacy ]
View
Cluster view
Default Level
1: Monitor level
Parameters
group-name: Group name, a string of 1 to 32 characters.
authentication: Specifies to authenticate a packet but not to encrypt it.
privacy: Specifies to authenticate and encrypt a packet.
read-view: Read-only view name, a string of 1 to 32 characters.
write-view: Read-write view name, a string of 1 to 32 characters.
notify-view: View name in which Trap messages can be sent, a string of 1 to 32 characters.
Description
Use the cluster-snmp-agent group command to configure the SNMPv3 group shared by a cluster
and set its access rights.
Use the undo cluster-snmp-agent group command to remove the SNMPv3 group shared by a
cluster.
Note that:
The command can be executed once on the management device only. This configuration will be
synchronized to the member devices in the whitelist, which is equal to configuring multiple
member devices at one time.
SNMPv3 group name will be retained if a cluster is dismissed or a member device is deleted from
the whitelist.
If the same group name as the current one has been configured on a member device, the current
group name will replace the original one.
Examples
# Create an SNMP group snmpgroup.
<aaa_0.Sysname> system-view
[aaa_0.Sysname] cluster
[aaa_0.Sysname-cluster] cluster-snmp-agent group v3 snmpgroup
20-25