Mld-Snooping Special-Query Source-Ip - HP E4510-48G Command Reference Manual

Default Level
2: System level
Parameters
None
Description
Use the mld-snooping source-deny command to enable IPv6 multicast source port filtering.
Use the undo mld-snooping source-deny command to disable IPv6 multicast source port filtering.
By default, IPv6 multicast source port filtering is disabled.
Examples
# Enable source port filtering for IPv6 multicast data on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet 1/0/1] mld-snooping source-deny

mld-snooping special-query source-ip

Syntax
mld-snooping special-query source-ip { current-interface | ipv6-address }
undo mld-snooping special-query source-ip
View
VLAN view
Default Level
2: System level
Parameters
current-interface: Specifies the source IPv6 link-local address of the VLAN interface of the current
VLAN as the source IPv6 address of MLD multicast-address-specific queries. If the current VLAN
interface does not have an IPv6 address, the default IPv6 address FE80::02FF:FFFF:FE00:0001 will
be used as the source IPv6 address of MLD multicast-address-specific queries.
ipv6-address: Specifies an IPv6 link-local address as the source IPv6 address of MLD
multicast-address-specific queries.
Description
Use the mld-snooping special-query source-ip command to configure the source IPv6 address of
MLD multicast-address-specific queries.
Use the undo mld-snooping special-query source-ip command to restore the default configuration.
By default, the
FE80::02FF:FFFF:FE00:0001.
This command takes effect only if MLD Snooping is enabled in the VLAN.
source IPv6 address of MLD multicast-address-specific
3-19
queries is