Display Rip - HP E4510-48G Command Reference Manual

Description
Use the default-route originate cost command to configure all the interfaces under the RIP process
to advertise a default route with the specified metric to RIP neighbors.
Use the undo default-route command to disable all the interfaces under the RIP process from
sending a default route.
By default, no default route is sent to RIP neighbors.
The RIP router with this feature configured will not receive any default routes from RIP neighbors.
Related commands: rip default-route.
Examples
# Configure all the interfaces under RIP process 1 to send only a default route with a metric of 2 to RIP
neighbors.
<Sysname> system-view
[Sysname] rip 100
[Sysname-rip-100] default-route only cost 2

display rip

Syntax
display rip [ process-id ]
View
Any view
Default Level
1: Monitor level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the display rip command to display the current status and configuration information of the
specified RIP process.
If process-id is not specified, information about all configured RIP processes is displayed.
Examples
# Display the current status and configuration information of all configured RIP processes.
<Sysname> display rip
RIP process : 1
RIP version : 1
Preference : 100
Checkzero : Enabled
Default-cost : 0
Summary : Enabled
Hostroutes : Enabled
3-3