Handshake Timeout - HP 3600 v2 Series Command Reference Manual

Table 45 Output description
Field
SSL Server Policy
PKI Domain
Ciphersuite

Handshake Timeout

Close-mode
Session Timeout
Session Cachesize
Client-verify
handshake timeout
Syntax
handshake timeout time
undo handshake timeout
View
SSL server policy view
Default level
2: System level
Parameters
time: Handshake timeout time in seconds, in the range of 180 to 7200.
Description
Use the handshake timeout command to set the handshake timeout time for an SSL server policy.
Use the undo handshake timeout command to restore the default.
By default, the handshake timeout time is 3600 seconds.
If the SSL server does not receive any packet from the SSL client before the handshake timeout time
expires, the SSL server will terminate the handshake process.
Related commands: display ssl server-policy.
Examples
# Set the handshake timeout time of SSL server policy policy1 to 3000 seconds.
<Sysname> system-view
[Sysname] ssl server-policy policy1
[Sysname-ssl-server-policy-policy1] handshake timeout 3000
Description
SSL server policy name.
PKI domain used by the SSL server policy.
Cipher suites supported by the SSL server policy.
Handshake timeout time of the SSL server policy, in seconds.
Close mode of the SSL server policy, which can be:
•
wait disabled: In this mode, the server sends a close-notify alert message to
the client and then closes the connection immediately without waiting for the
close-notify alert message of the client.
•
wait enabled: In this mode, the server sends a close-notify alert message to
the client and then waits for the close-notify alert message of the client. Only
after receiving the expected message, does the server close the connection.
Session timeout time of the SSL server policy, in seconds.
Maximum number of buffered sessions of the SSL server policy.
Whether the SSL server policy requires the client to be authenticated.
283