Rip Default-Route - HP E4510-48G Command Reference Manual

Parameters
md5: MD5 authentication mode.
rfc2453: Uses the message format defined in RFC 2453 (IETF standard).
rfc2082: Uses the message format defined in RFC 2082.
key-id: MD5 key number, in the range of 1 to 255.
key-string: MD5 key string with 1 to 16 characters in plain text format, or 1 to 24 characters in cipher
text format. When the display current-configuration command is used to display system information,
a 24-character cipher string is displayed as the MD5 key string.
simple: Plain text authentication mode.
password: Plain text authentication string with 1 to 16 characters.
Description
Use the rip authentication-mode command to configure RIPv2 authentication mode and parameters.
Use the undo rip authentication-mode command to cancel authentication.
Note that the key string you configured can overwrite the old one if there is any.
Related commands: rip version.
Examples
# Configure MD5 authentication on VLAN-interface 10 with the key string being rose in the format
defined in RFC 2453.
<Sysname> system-view
[Sysname] interface vlan-interface 10
[Sysname-Vlan-interface10] rip version 2
[Sysname-Vlan-interface10] rip authentication-mode md5 rfc2453 rose

rip default-route

Syntax
rip default-route { { only | originate } [ cost cost ] | no-originate }
undo rip default-route
View
Interface view
Default Level
2: System level
Parameters
only: Advertises only a default route.
originate: Advertises a default route and other routes.
cost: Cost of the default route, in the range 1 to 15.
no-originate: Advertises routes other than a default route.
3-17