Ip Http Port - HP E4510-48G Command Reference Manual

Description
Use the ip http enable command to enable the HTTP service.
Use the undo ip http enable command to disable the HTTP service.
The device can act as the HTTP server and the users can access and control the device through the
Web function only after the HTTP service is enabled.
Examples
# Enable the HTTP service.
<Sysname> system-view
[Sysname] ip http enable
# Disable the HTTP service.
<Sysname> system-view
[Sysname] undo ip http enable

ip http port

Syntax
ip http port port-number
undo ip http port
View
System view
Default Level
3: Manage level
Parameters
port-number: Port number of the HTTP service, in the range 1 to 65535.
Description
Use the ip http port command to configure the port number of the HTTP service.
Use the undo ip http port command to restore the default.
By default, the port number of the HTTP service is 80.
Note that this command does not check whether the configured port number conflicts with that of an
existing service. Therefore, you must ensure that the port number is not used by another service
before the configuration.
Examples
# Configure the port number of the HTTP service as 8080.
<Sysname> system-view
[Sysname] ip http port 8080
8-3