Honda Accord 2008 Manual page 676

07/11/02 09:17:58 61TA0000_110_0357
33. Connect PGM-FI main relay 2 (FUEL PUMP) 4P
connector terminals No. 1 and No. 2 with a jumper
wire.
＊１４
PGM-FI MAIN RELAY 2 (FUEL PUMP) 4P CONNECTOR
34. Turn the ignition switch to ON (II), and measure
voltage between fuel tank unit 4P connector
terminal No. 2 and body ground.
＊１５
Is there battery voltage?
YES
(FUEL PUMP).
NO −
• Repair open in the wire between the driver's
under-dash fuse/relay box (D10) and the fuel tank
unit 4P connector.
• If the wire is OK, replace the driver's under-dash
fuse/relay box (see page 22-84).
35. Turn the ignition switch to LOCK (0).
IG1 FUEL PUMP
JUMPER WIRE
Terminal side of female terminals
FUEL TANK UNIT 4P CONNECTOR
FUEL PUMP (PNK)
Wire side of female terminals
−
Replace PGM-FI main relay 2
36. Check for continuity between fuel tank unit 4P
connector terminal No. 4 and body ground.
FUEL TANK UNIT 4P CONNECTOR
GND (BLK)
Wire side of female terminals
Is there continuity?
YES − Replace the fuel pump (see page 11-373).
−
NO Repair open in the wire between the fuel tank
unit 4P connector and G603; 4-door (see page
22-50), 2-door (see page 22-52).
＊１６
11-357