Fuel Line/Quick-Connect Fitting Removal - Honda Accord 2008 Manual

07/11/02 09:18:29 61TA0000_110_0366
Fuel Supply System
Fuel Line/Quick-Connect Fitting
Precautions (cont'd)
A disconnected quick-connect fitting can be
reconnected, but the retainer on the mating line cannot
be reused once it has been removed from the line.
Replace the retainer when:
• replacing the fuel rail.
• replacing the fuel line.
• replacing the fuel pump.
• replacing the fuel filter.
• replacing the EVAP canister.
• replacing the fuel fill pipe.
• replacing the fuel tank.
• it has been removed from the line.
• it is damaged.
Use the same manufacturer retainer and the same size
retainer when the replacing the retainer.
Location Manufacturer
A Tokai
B Tokai
C Sanoh
D Sanoh
E Tokai
F Tokai
(PZEV
model)
11-366 11-366
Retainer Line
color diameter
Blue 0.3 in.
green (8 mm)
Green 0.2 in.
(6.3 mm)
White 0.4 in.
(9.5 mm)
White 0.5 in.
(12 mm)
Natural 0.5 in.
(12 mm)
Green 1.1 in.
(28.6 mm)
Fuel Line/Quick-Connect Fitting
Removal
NOTE: Before you work on the fuel lines and fittings,
read the Fuel Line/Quick-Connect Fitting Precautions
(see page 11-365).
1. If equipped, remove the quick-connect fitting cover
from the fuel line. Raise the cover (A) from the fuel
line (B), and remove it as shown.
A
B
2. Relieve the fuel pressure (see page 11-358).
3. Check the fuel quick-connect fittings (A) for dirt,
and clean them if needed.
A
ＴＡ０８ＡＥ４Ａ２０３２６４２８００１ＫＡＡＴ００
＊０１
＊０２