Honda Accord 2008 Manual page 691

Hide thumbs Also See for Accord 2008:

Table of Contents

07/11/02 09:18:33 61TA0000_110_0372

Fuel Supply System

Fuel Line/Quick-Connect Fitting Installation (cont'd)

5. When you reconnect the connector with the old

retainer, make sure the connection is secure and

the tabs are firmly locked into place; check visually

and also by pulling the connector. When you

replace the fuel line with a new one, make sure you

remove the ring pull upwards after you confirm the

connection is secure.

NOTE: Before you remove the ring pull, make sure

the fuel line connection is secure. If the connection

is not secure, the ring pull could break when you try

to remove it.

Connection to new fuel line

6. Reconnect the negative cable to the battery, and

turn the ignition switch to ON (II) (but do not

operate the starter motor). The fuel pump will run

for about 2 seconds, and fuel pressure will rise.

Repeat this two or three times, and check that there

is no leakage in the fuel supply system.

7. If equipped, install the quick-connect fitting cover.

Set the groove of the cover (A) on the fuel line (B)

as shown, then install it. Make sure the cover is

firmly locked in place.

Chapters

Table of Contents