Command Details - HP ProCurve 5400zl Reference Manual

Command Line Interface Reference Guide
Edge1(config)# int A1 qinq port-type customer-network
Edge1(config)# svlan 200
Edge1(svlan-200)# untagged A2
Edge1(svlan-200)# exit
Edge1(config)# int A2 qinq port-type customer-network
Edge2(config)# svlan 100
Edge2(svlan-100)# untagged A1
Edge2(svlan-100)# exit
Edge2(config)# int A1 qinq port-type customer-network
Edge2(config)# svlan 200
Edge2(svlan-200)# untagged A2
Edge2(svlan-200)# exit
Edge2(config)# int A2 qinq port-type customer-network
Configure the provider ports leading to the core of the network:
Edge1(config)# svlan 100 tagged A3, A4
Edge1(config)# svlan 200 tagged A3, A4
Edge1(config)# interface A3,A4 qinq port-type provider-network

COMMAND DETAILS

access-group (p. 663)
address (p. 664)
all (p. 665)
anycast (p. 665)
auto (p. 665)
autoconfig (p. 665)
binary-range (p. 666)
connection-rate-filter (p. 666)
dhcp (p. 666)
dhcp-bootp (p. 666)
dhcp-snooping (p. 666)
direction (p. 666)
dscp (p. 666)
enable (p. 667)
eui-64 (p. 667)
access-group
■ [no] svlan VLAN-ID ip access-group ACCESS-GROUP
Usage: [no] ip access-group <ACL-ID> <in|out>
in
out
vlan
connection-rate-filter Manage new conection rates originating in this VLAN
Description: Apply the specified access control list on this VLAN interface.
© 2009 Hewlett-Packard Development Company, L.P.
forbid (p. 667)
full (p. 667)
host (p. 667)
integer-range (p. 667)
ip (p. 667)
ip-addr (p. 668)
ipv6 (p. 668)
ipv6-addr (p. 668)
ipv6-addr/mask (p. 668)
jumbo (p. 669)
link-local (p. 669)
mirror (p. 669)
mirror_session_name (p. 669)
monitor (p. 669)
monitor_mirror_session_id (p.
670)
Match packets this device will route to another VLAN
Match packets this device will route onto this VLAN
Match packets that originate within this VLAN
The ACL can match either packets that are routed from this VLAN
to another VLAN, packets that will be routed from another VLAN
to this VLAN, packets that originate on this VLAN, or it can
manage new connection rates for virus throttling.Connection rate
filter ACLs should be applied as connection-rate-filter only.
name (p. 670)
priority (p. 670)
protocol (p. 670)
protocol-group (p. 671)
protocols (p. 671)
qos (p. 671)
rapid-commit (p. 671)
src-ip (p. 671)
tagged (p. 671)
unblock (p. 672)
untagged (p. 672)
voice (p. 672)
well-defined (p. 672)
svlan
663