Auto-Tftp; Overview; Command Structure; Examples - HP ProCurve 5400zl Reference Manual

OVERVIEW

Category:
Primary context:
Related Commands
Usage: [no] auto-tftp [<IPV4-ADDR | IPV6-ADDR> <FILENAME-STR>]
Description: Enable/disable automatic software image download via TFTP during

COMMAND STRUCTURE

■ auto-tftp

server-ip
(p. 70)
filename
■
■ auto-tftp server-ipv6
(IPV6-ADDR)
filename
■

EXAMPLES

Example: auto-tftp IP-ADDR FILENAME
Set the device to boot using image2 located on TFTP server 10.10.2.40, if the image version is different
from the one already on the switch:
ProCurve(config)# auto-tftp 10.10.2.40 image2

COMMAND DETAILS

filename (p. 70)
filename
■ auto-tftp IP-ADDR FILENAME
The software image file-name.
■ auto-tftp IPV6-ADDR FILENAME
The software image file-name.
server-ip
■ auto-tftp IP-ADDR
© 2009 Hewlett-Packard Development Company, L.P.
File Transfer
config
the section called client" (page 685)
boot. The software image will be downloaded if it has a different
version from the software running on the switch. The command
requires the parameters to be specified when used without 'no'.
o IPV4-ADDR - specifies the TFTP server IPv4 address to download
a software image from.
o IPV6-ADDR - specifies the TFTP server IPv6 address to download
a software image from.
o FILENAME-STR - specifies the file-name to download.
-- IPv4 address of the TFTP server to download a software image from. (IP-ADDR)
-- The software image file-name. (ASCII-STR)
-- IPv6 address of the TFTP server to download a software image from.
(p. 71)
-- The software image file-name. (ASCII-STR)
server-ip (p. 70)
auto-tftp
(p. 70)
(p. 70)
server-ipv6 (p. 71)
70