Command Line Interface Reference Guide
Usage: [no] ip ospf [...]
Description: configure Open Shortest Path First (OSPF)
Next Available Options:
ip-addr
-- Specify the IP address the request is for. (IP-ADDR)
■
all
-- Process the request for all IP
■
■ [no] interface vlan VLAN-ID ip ospf
Usage: [no] ip ospf [...]
Description: Enable/disable/configure Open Shortest Path First (OSPF)
Next Available Options:
passive
■
area
-- Specify an OSPF
■
authentication-key
■
authentication
■
md5-auth-key-chain
■
cost
< 1 to 65535 > -- Set metric of this
■
dead-interval
■
hello-interval
■
priority
< 0 to 255 > -- Set priority of this router as a designated
■
retransmit-interval
■
transit-delay
■
ip-addr
-- Specify the IP address the request is for. (IP-ADDR)
■
all
-- Process the request for all IP
■
out
■ [no] interface [ETHERNET] PORT-LIST rate-limit all out
Set limits for all outbound traffic.
Next Available Options:
percent
■
kbps
< 0 to 10000000 > -- Specify limit of allowed inbound or outbound traffic in
■
kilobits-per-second on the specified port(s). Actual limits are in steps of 100Kbps to 100Mbps
(granularity is 1% of the lowest related media speed).
© 2009 Hewlett-Packard Development Company, L.P.
protocol parameters on the interface.
Called without 'no', the command configures OSPF parameter on
interface. Otherwise ('no' is specified), the command remove
specified ospf parameter on the interface. Use 'ip ospf ?' to
get a list of all possible options.
protocol on the VLAN interface.
Called without 'no', the command enables OSPF on the interface.
Otherwise ('no' is specified), the command disables OSPF on the
interface. The command can be followed by an OSPF configuration
command. Use 'ip ospf ?' to get a list of all possible options.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
-- Configures an ospf interface as passive.
area.(p. 221)
-- Set simple authentication method and
-- Disable
authentication.(p. 223)
-- Set MD5 authentication method and key
< 1 to 65535 > -- Set dead interval in seconds; the default is
< 1 to 65535 > -- Set hello interval in seconds; the default is
< 1 to 3600 > -- Set retransmit interval in seconds; the default is
< 1 to 3600 > -- Set transit delay in seconds; the default is
< 0 to 100 > -- Specify limit as percent of inbound or outbound
addresses.(p. 219)
(p. 258)
interface.(p. 229)
addresses.(p. 219)
(p. 246)
(p. 241)
key.(p. 223)
chain.(p. 250)
40.(p. 229)
10.(p. 236)
router.(p. 265)
1.(p. 279)
(p. 241)
traffic.(p. 258)
interface
5.(p. 273)
257