Trunk - HP ProCurve 5400zl Reference Manual

OVERVIEW
Category:
Primary context:
Related Commands
Usage: trunk [ethernet] PORT-LIST
no trunk [ethernet] PORT-LIST
Description: Add or remove a switch port from a port trunk.
COMMAND STRUCTURE

■ trunk

portlist
PORT-LIST)
trunk-group
■
(p. 701)
type
■
trunk.
© 2009 Hewlett-Packard Development Company, L.P.
config
switch-interconnect (page 675)
<trk1|trk2...trkN>
[trunk|lacp]
Each port on the switch (up to 8 ports total) can be made
a member of a port trunk. The 'no trunk' command can be used
to remove ports from an existing trunk. The switch supports
any one of the following trunk groups:
Trunk - A static port grouping in which no protocols are used
to create or maintain the trunk (type 'trunk').
LACP - A port grouping in which trunk membership is dynamically
determined using the IEEE 802.1ad Link Aggregation Protocol.
For LACP trunks the trunk group may instead be manually
configured as static trunk.
Manually configuring a static LACP trunk allows you to specify
which ports are members and still configure advanced LACP
features (type 'lacp').
Any trunk group can have up to 8 member ports. All ports that
belong to the same trunk group must have the same port type.
All trunk groups use an algorithm that considers the source and
destination MAC addresses for load distribution.
General Considerations: To avoid broadcast storms, or
loops in your network while configuring trunks, first
disable or disconnect all the ports you wish to add or
remove from both sides of the trunk.
the trunk, enable or re-connect the ports.
-- Specify the ports that are to be added to/removed from a trunk. ([ethernet]
(p. 701)
< Trk1 | Trk2 | Trk3 | ... > -- Specify the trunk group a port is to be a member of.
< Trunk | LACP | dt-lacp | ... > -- Specify protocol to use on a manually configured
(p. 702)
Once done configuring
trunk
700