HP ProCurve 5400zl Reference Manual page 620

Command Line Interface Reference Guide
Description: Enable/Disable SNMP support for the hpSwitchAuthentication MIB.
Next Available Options:
included
■
excluded
■
included
■ snmp-server mib hpSwitchAuthMIB included
Enables SNMP support for the hpSwitchAuthentication MIB.
informs
■ snmp-server host IP-ADDR informs
Specify if informs will be sent, rather than notifications.
Next Available Options:
retries < 0 to 255 > -- Specify the number of retries for
■
timeout
■
(NUMBER)
■ snmp-server host IPV6-ADDR informs
Specify if informs will be sent, rather than notifications.
Next Available Options:
retries < 0 to 255 > -- Specify the number of retries for
■
timeout
■
(NUMBER)
ip-addr
■ snmp-server response-source IP-ADDR
IP Address for the source ip address field in the snmp response pdu.
■ snmp-server trap-source IP-ADDR
IP Address for the source ip address field in the trap pdu.
link-change
■ [no] snmp-server enable traps link-change [ETHERNET] PORT-LIST
Traps for link-up and link-down.
location
■ snmp-server location LOCATION
© 2009 Hewlett-Packard Development Company, L.P.
When the MIB access is enabled, Manager read/write access
to the MIB is permitted. Operator read/write access to the MIB
is always denied. For security reasons, network administrators
are encouraged to disable SNMPV2c before using the MIB.
-- Enables SNMP support for the hpSwitchAuthentication
-- Disables SNMP support for the hpSwitchAuthentication
< 1 to 21474836 > -- Specify the interval between retries for informs, in seconds.
(p. 620)
< 1 to 21474836 > -- Specify the interval between retries for informs, in seconds.
(p. 620)
MIB.(p. 618)
MIB.(p. 616)
informs.(p. 620)
informs.(p. 620)
snmp-server
618