HP ProCurve 5400zl Reference Manual page 218

Command Line Interface Reference Guide
Usage: [no] ip access-group <ACL-ID> <in|out>
in
out
vlan
connection-rate-filter Manage new conection rates originating in this VLAN
Description: Apply the specified access control list on this VLAN interface.
Next Available Option:
direction
■
address
■ [no] interface loopback < 0 to 7 > ip address
Usage: [no] ip address [IP-ADDR]
Description: Set IP parameters for communication within an IP network.
Parameters:
o IP-ADDR- Assign an IP address to the loopback interface.
Multiple addresses may be configured on a single loopback interface.
Next Available Option:
ip-addr -- Interface IP address. (IP-ADDR)
■
■ [no] interface vlan VLAN-ID ip address
Usage: [no] ip address [dhcp-bootp|IP-ADDR/mask-LENGTH]
Description: Set IP parameters for communication within an IP network.
Parameters:
o dhcp-bootp - The switch attempts to get its configuration from a
© 2009 Hewlett-Packard Development Company, L.P.
Match packets this device will route to another VLAN
Match packets this device will route onto this VLAN
Match packets that originate within this VLAN
The ACL can match either packets that are routed from this VLAN
to another VLAN, packets that will be routed from another VLAN
to this VLAN, packets that originate on this VLAN, or it can
manage new connection rates for virus throttling.Connection rate
filter ACLs should be applied as connection-rate-filter only.
< in | out | connection-rate-filter | ... > --
Each loopback Interface represents an IP interface having
its own unique configuration.
for which the configuration is applied can be specified
implicitly by preceding the phrase 'ip address' with the
'interface loopback <num>' keyword and argument.
can also be called explicitly when called directly from a
Loopback context.
affects the interface identified by the context.
Each VLAN represents an IP interface having its own unique
configuration. The VLAN for which the configuration is
applied can be specified implicitly by preceding the
phrase 'ip address' with the 'vlan VLAN-ID' keyword and
argument. It can also be called explicitly when called
directly from a VLAN context.
command affects the VLAN identified by the context.
(p. 231)
The loopback interface
In the latter case the command
(p. 241)
In the latter case the
interface
It
216