HP ProCurve 5400zl Reference Manual page 732

Command line interface, switch software
Hide thumbs Also See for ProCurve 5400zl:
Table of Contents

Advertisement

Command Line Interface Reference Guide
■ [no] vlan VLAN-ID ip rip IP-ADDR
Specify the IP address the request is for.
Next Available Options:
authentication-type
authentication-key
metric
< 1 to 15 > -- Set metric for this
poison-reverse
receive
< V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming
send
< disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing
747)
rip-compatible
packets.(p. 747)
■ vlan VLAN-ID ip pim-dense ip-addr
Usage: ip pim-dense [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-DM packets sent out on this
Next Available Options:
ip-addr
-- Specify IP address. (IP-ADDR)
any
-- Dynamically determine IP
■ vlan VLAN-ID ip pim-dense ip-addr IP-ADDR
Specify IP address.
■ vlan VLAN-ID ip pim-sparse ip-addr
Usage: ip pim-sparse [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-SM packets sent out on this
Next Available Options:
ip-addr
-- Specify IP address. (IP-ADDR)
any
-- Dynamically determine IP
■ vlan VLAN-ID ip pim-sparse ip-addr IP-ADDR
Specify IP address.
■ [no] vlan VLAN-ID vrrp vrid < 1 to 255 > virtual-ip-address IP-ADDR/mask-LENGTH
Specify IP address/mask.
© 2009 Hewlett-Packard Development Company, L.P.
< none | text > -- Set authentication type used on this
-- Set RIP authentication key (maximum 16
-- Enable/disable poison reverse on this
< V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP configuration. The default is 'any'.
This command also enable the PIM-DM protocol on the VLAN interface.
address.(p. 716)
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP configuration. The default is 'any'.
This command also enable the PIM-SM protocol on the VLAN interface.
address.(p. 716)
interface.(p. 734)
interface.(p. 741)
(p. 729)
(p. 729)
interface.(p. 718)
characters).(p. 717)
packets.(p. 745)
packets.(p.
vlan
730

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 3500ylProcurve 8200zl6200yl

Table of Contents