HP ProCurve 5400zl Reference Manual page 565

Command Line Interface Reference Guide
routers -- Show the IPv6 Router table
■
route -- Show the IPv6 routing
■
nd -- Show the IPv6 Neighbor Discovery
■
mld -- Invoked without any parameters, shows per-VLAN MLD status, or, if VLANs are disabled
■
displays the global MLD
neighbors
■
authorized-managers
■
■ show class ipv6 IPV6
Enter ipv6 class.
ipv6-addr
■ show ipv6 route IPV6-ADDR
Destination IPv6 address to display the routes to.
■ show ipv6 mld vlan VLAN-ID group IPV6-ADDR
Show MLD VLAN group address information.
irdp
■ show ip irdp
Usage: show ip irdp
Description: Show IRDP (ICMP Router Discovery Protocol) settings.
ist
■ show spanning-tree [ETHERNET] PORT-LIST config instance ist
Show the information for the internal spanning tree (IST) instance.
■ show spanning-tree [ETHERNET] PORT-LIST instance ist
Show the information for the internal spanning tree (IST) instance.
Next Available Option:
detail -- Show spanning tree extended details Port, Bridge, Rx, and Tx
■
■ show spanning-tree config instance ist
Show the information for the internal spanning tree (IST) instance.
■ show spanning-tree instance ist
Show the information for the internal spanning tree (IST) instance.
Next Available Option:
detail -- Show spanning tree extended details Port, Bridge, Rx, and Tx
■
■ show spanning-tree pending instance ist
© 2009 Hewlett-Packard Development Company, L.P.
table(p. 587)
status(p. 570)
-- Displays information on the IPv6 neighbor discovery
-- Show IPV6 addresses allowed to manage the
entries(p. 587)
settings(p. 573)
cache(p. 573)
switch(p. 532)
report.(p. 546)
report.(p. 546)
show
563