HP ProCurve 5400zl Reference Manual page 280

Command Line Interface Reference Guide
Next Available Options:
dhcp-snooping
■
ip -- Configure various IP parameters for the
■
ipv6 -- Configure various IP parameters for the
■
auto -- Cause each port identified in the port list to learn its VLAN membership using the GARP
■
VLAN Registration Protocol (GVRP) ([ethernet] PORT-LIST)
connection-rate-filter
■
blocked by the connection rate
monitor
■
name -- Set the VLAN's name (ASCII-STR)
■
protocol
■
qos -- Set VLAN-based
■
tagged -- Assign ports to current VLAN as tagged ([ethernet] PORT-LIST)
■
untagged
■
forbid -- Prevent ports from becoming a member of the current VLAN ([ethernet] PORT-LIST)
■
(p. 234)
voice -- Labels this VLAN as a Voice VLAN, allowing you to separate, prioritize, and authenticate
■
voice traffic moving through your
jumbo -- Labels this VLAN as a Jumbo VLAN, allowing you to pass packets up to 9220 bytes
■
in size(p. 246)
tagged
■ [no] interface vlan VLAN-ID tagged [ETHERNET] PORT-LIST
Usage: [no] tagged [ethernet] PORT-LIST
Description: Assign ports to current VLAN as tagged.
■ [no] interface svlan VLAN-ID tagged [ETHERNET] PORT-LIST
Usage: [no] tagged [ethernet] PORT-LIST
Description: Assign ports to current VLAN as tagged.
timer-interval
■ interface vlan VLAN-ID ip-recv-mac-address MAC-ADDR interval < 1 to 255 >
Timeout interval in seconds <1-255>.
Range: < 1 to 255 >
track
■ [no] interface vlan VLAN-ID vrrp vrid < 1 to 255 > track
Usage: [no] vrrp vrid <VRID> track <vlan <VLAN-ID-RANGE>|interface <LPORT-LIST>>
no vrrp vrid <VRID> track
Description: Enable/disable tracking for VR.
© 2009 Hewlett-Packard Development Company, L.P.
-- (p. 230)
-- Re-enables access to a host or set of hosts that has been previously
-- Define either the VLAN is to be monitored or
-- Set a predefined protocol for the current VLAN.
priority(p. 268)
-- Assign ports to current VLAN as untagged ([ethernet] PORT-LIST)
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
VLAN(p. 240)
VLAN(p. 244)
filter(p. 228)
(p. 254)
network(p. 283)
(p. 225)
not(p. 252)
(p. 266)
(p. 278)
interface
(p. 282)
278