HP ProCurve 5400zl Reference Manual page 245

Command Line Interface Reference Guide
■ interface vlan VLAN-ID ip pim-dense ip-addr
Usage: ip pim-dense [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-DM packets sent out on this
Next Available Options:
ip-addr -- Specify IP address. (IP-ADDR)
■
any -- Dynamically determine IP
■
■ interface vlan VLAN-ID ip pim-dense ip-addr IP-ADDR
Specify IP address.
■ interface vlan VLAN-ID ip pim-sparse ip-addr
Usage: ip pim-sparse [ip-addr IP-ADDR|any]
Description: Set the source IP address for the PIM-SM packets sent out on this
Next Available Options:
ip-addr -- Specify IP address. (IP-ADDR)
■
any -- Dynamically determine IP
■
■ interface vlan VLAN-ID ip pim-sparse ip-addr IP-ADDR
Specify IP address.
■ [no] interface vlan VLAN-ID vrrp vrid < 1 to 255 > virtual-ip-address IP-ADDR/mask-LENGTH
Specify IP address/mask.
■ interface vlan VLAN-ID vrrp vrid < 1 to 255 > primary-ip-address IP-ADDR
Specify IP address.
■ [no] interface svlan VLAN-ID ip address IP-ADDR/mask-LENGTH
Interface IP address/mask.
ip-recv-mac-address
■ [no] interface vlan VLAN-ID ip-recv-mac-address
Usage: [no] ip-recv-mac-address <macaddress> interval <1-255>
Description:
To associate L3-Mac-Address for a VLAN.
ip-recv-mac-address <mac-address> interval <1-255>
© 2009 Hewlett-Packard Development Company, L.P.
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP configuration. The default is 'any'.
This command also enable the PIM-DM protocol on the VLAN interface.
address.(p. 221)
interface. You can either explicitly specify one of the existing
VLAN's IP addresses or use 'any' option to dynamically determine
it from the VLAN's current IP configuration. The default is 'any'.
This command also enable the PIM-SM protocol on the VLAN interface.
address.(p. 221)
Associates a L3-mac-address with a VLAN.
(p. 241)
(p. 241)
interface
243