HP ProCurve 5400zl Reference Manual page 222

Command Line Interface Reference Guide
Process the request for all IP addresses.
Next Available Options:
area -- Specify an OSPF
■
cost < 1 to 65535 > -- Set metric of this
■
■ [no] interface vlan VLAN-ID ip ospf all
Process the request for all IP addresses.
Next Available Options:
passive
■
area -- Specify an OSPF
■
authentication-key
■
authentication
■
md5-auth-key-chain
■
cost < 1 to 65535 > -- Set metric of this
■
dead-interval
■
hello-interval
■
priority < 0 to 255 > -- Set priority of this router as a designated
■
retransmit-interval
■
transit-delay
■
■ [no] interface vlan VLAN-ID ip rip all
Process the request for all IP addresses.
Next Available Options:
authentication-type
■
authentication-key
■
metric < 1 to 15 > -- Set metric for this
■
poison-reverse
■
receive < V1-only | V2-only | V1-or-V2 | ... > -- Define RIP version for incoming
■
send < disabled | V1-only | V1-compatible-V2 | ... > -- Define RIP version for outgoing
■
275)
rip-compatible
■
packets.(p. 274)
■ interface vlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate filter
■ interface vlan VLAN-ID monitor all < In | Out | Both >
Monitor all traffic.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
■ Both -- Monitor all inbound and outbound traffic
Next Available Option:
mirror -- Mirror
■
© 2009 Hewlett-Packard Development Company, L.P.
area.(p. 221)
-- Configures an ospf interface as passive.
area.(p. 221)
-- Set simple authentication method and
-- Disable authentication.(p. 223)
-- Set MD5 authentication method and key
< 1 to 65535 > -- Set dead interval in seconds; the default is
< 1 to 65535 > -- Set hello interval in seconds; the default is
< 1 to 3600 > -- Set retransmit interval in seconds; the default is
< 1 to 3600 > -- Set transit delay in seconds; the default is
< none | text > -- Set authentication type used on this
-- Set RIP authentication key (maximum 16
-- Enable/disable poison reverse on this
< V1-only | V2-only | V1-or-V2 > -- Define RIP version for incoming and outgoing
destination.(p. 251)
interface.(p. 229)
(p. 258)
key.(p. 223)
interface.(p. 229)
interface.(p. 250)
interface.(p. 262)
chain.(p. 250)
40.(p. 229)
10.(p. 236)
router.(p. 265)
5.(p. 273)
1.(p. 279)
interface.(p. 224)
characters).(p. 223)
packets.(p. 273)
packets.(p.
interface
220