HP ProCurve 5400zl Reference Manual page 271

Command line interface, switch software
Hide thumbs Also See for ProCurve 5400zl:
Table of Contents

Advertisement

Command Line Interface Reference Guide
Next Available Options:
dscp
-- Specify DSCP policy to use.
priority
< 0 | 1 | 2 | ... > -- Specify priority to use.
■ [no] interface svlan VLAN-ID qos
Usage: [no] qos [dscp <0|1...63|af11|af12|af13|af21|af22|af23|af31|af32|
Description: Set VLAN-based priority. The 'dscp' or 'priority' must
Next Available Options:
dscp
-- Specify DSCP policy to use.
priority
< 0 | 1 | 2 | ... > -- Specify priority to use.
querier
■ [no] interface vlan VLAN-ID ip igmp querier
Usage: [no] ip igmp querier [interval <seconds>]
Description: Specify querier/non-querier capability for the VLAN. IGMP
Next Available Option:
interval
■ [no] interface vlan VLAN-ID ipv6 mld querier
Usage: [no] vlan < vid > ipv6 mld querier
Description: This command disables or re-enables the ability for the switch
© 2009 Hewlett-Packard Development Company, L.P.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
af33|af41|af42|af43|ef|cs0..cs7|000000|000001...111111> |
priority <0-7>]
be specified if 'no' is not used. Using 'no' configures
the switch not to apply a VLAN priority override to this
VLAN's packets.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
queries are not sent when the mode is disabled. When
enabled, the device cannot become Querier for the subnet
unless the VLAN has an IP Address (use the 'show ip' command
to determine this).
Querier-capable device in order for IGMP to function
properly.
The querier interval setting modifies the time (in
seconds) between IGMP queries.
< 5 to 300 > -- Sets the interval in seconds between IGMP queries (default: 125)
to become querier if necessary. The no version of the command
disables the querier function on the switch.
The show ipv6 mld config command displays the current querier
command. (Default Querier Capability: Enabled.)
(p. 231)
(p. 265)
(p. 231)
(p. 265)
Each subnet must have at least one IGMP
interface
(p. 240)
269

Advertisement

Table of Contents
loading

This manual is also suitable for:

Procurve 3500ylProcurve 8200zl6200yl

Table of Contents