Console; Overview; Command Structure; Examples - HP ProCurve 5400zl Reference Manual

OVERVIEW

Category:
Primary context:
Related Commands
Usage: console ...
Description: Set various console parameters. Use 'console ?' to get a list

COMMAND STRUCTURE

■ console

baud-rate
device connect sessions initiated through the Console port
■ console events
Log (p. 93)
■ console flow-control
(p. 93)
■ console inactivity-timer
the Console port before the switch terminates a communication session
■ console local-terminal
console or telnet session (default is vt100)
■ console screen-refresh
on the repeat command
■ console terminal
telnet sessions (default is vt100)

EXAMPLES

Example: console <...>
Configure the switch to use the following console settings:
■ VT100 operation
■ 19,200 baud
■ No flow control
■ 10-minute inactivity time
■ Critical log events
ProCurve(config)# console terminal vt100 baud-rate 19200 flow-control none
inactivity-timer 10 events
critical
Command will take effect after saving configuration and reboot.
© 2009 Hewlett-Packard Development Company, L.P.
Switch Management
config
show (page 511)
repeat (page 470)
of all configurable parameters.
The non-configurable parameters and their default values are:
Data bits = 8; Parity = None; Stop bits = 1.
< speed-sense | 1200 | 2400 | ... > -- Set the data transmission speed for the
< None | Debug | All | ... > -- Set level of the events displayed in the device's Events
< XON/XOFF | None > -- Set the Flow Control Method; default is xon-xoff
< 0 | 1 | 5 | ... > -- Set the number of minutes of no activity detected on
< VT100 | NONE | ANSI > -- Set type of terminal being used for the current
< 1 | 3 | 5 | ... > -- Set default number of seconds before screen is refreshed
(p. 94)
< VT100 | NONE | ANSI > -- Set type of terminal being used for all console and
(p. 95)
(p. 93)
(p. 94)
console
(p. 94)
92