HP ProCurve 5400zl Reference Manual page 262

Command Line Interface Reference Guide
Next Available Options:
ip-addr -- Set the source IP address for the PIM-SM packets sent out on this
■
lan-prune-delay
■
hello-interval
■
on this interface(p. 236)
hello-delay
■
transmitted on this
override-interval
■
LAN Prune Delay option on this
propagation-delay
■
a LAN Prune Delay option on this
dr-priority
■
process(p. 231)
nbr-timeout
■
poe_lldp_detect
■ interface [ETHERNET] PORT-LIST poe-lldp-detect < disabled | enabled >
Usage: poe-lldp-detect [disabled|enabled]
Description: Enabling this feature causes the port to allocate power
Supported Values:
■ disabled
■ enabled
poe_value
■ interface [ETHERNET] PORT-LIST poe-value < 1 | 2 | 3 | ... >
Usage: poe-value [1-17]
Description: Maximum PoE allocation specified with a value in watts.
Supported Values:
■ 1
■ 2
■ 3
■ 4
■ 5
■ 6
■ 7
© 2009 Hewlett-Packard Development Company, L.P.
PIM-SM on the interface. Use 'ip pim-sparse ?' to get the list
of all configuration options. This command can be used in the
VLAN context or in the global context with the 'vlan <VLAN-ID>'
prefix.
-- Turn on/off the LAN Prune Delay Option on this
< 5 to 300 > -- Set the frequency at which PIM Hello messages are transmitted
< 0 to 5 > -- Set the maximum time before a triggered PIM Hello message is
interface(p. 236)
< 500 to 6000 > -- Set the value inserted into the Override Interval field of a
interface(p. 258)
< 250 to 2000 > -- Set the value inserted into the LAN Prune Delay field of
-- Set the priority value to use on the interface in the Designated Router election
< 60 to 8000 > -- Set the neighbour loss time interval for this
based on the link-partner's capabilities via LLDP.
By default, poe information detected though LLDP
are ignored as not all PoE devices properly support LLDP.
By default, power-over-ethernet allocation is automatic by
usage of the powered device with a maximum set at 17W
This can be changed so the POE allocation is fixed at
whatever poe-value is set to and by setting the port
allocation to be by value using: poe-allocate-by value.
interface(p. 266)
interface
interface(p. 241)
interface(p. 247)
interface(p. 255)
260