HP ProCurve 5400zl Reference Manual page 267

Command Line Interface Reference Guide
Next Available Options:
ip-addr -- Specify IP address. (IP-ADDR)
■
lowest -- Dynamically determine lowest IP
■
priority
■ interface [ETHERNET] PORT-LIST power-over-ethernet < critical | high | low >
Usage: [no] power-over-ethernet [critical|high|low]
Description: Enable/Disable per-port power distribution. Specifying critical,
Supported Values:
■ critical
■ high
■ low
■ interface [ETHERNET] PORT-LIST qos priority < 0 | 1 | 2 | ... >
Specify priority to use.
Supported Values:
■ 0
■ 1
■ 2
■ 3
■ 4
■ 5
■ 6
■ 7
■ interface vlan VLAN-ID ip ospf priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
■ interface vlan VLAN-ID ip ospf IP-ADDR priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
■ interface vlan VLAN-ID ip ospf all priority < 0 to 255 >
Set priority of this router as a designated router.
Range: < 0 to 255 >
■ interface vlan VLAN-ID qos priority < 0 | 1 | 2 | ... >
Specify priority to use.
Supported Values:
© 2009 Hewlett-Packard Development Company, L.P.
'0.0.0.0') the virtual router uses numerically lowest IP address
of the VLAN. The default value is 'lowest'.
high, or low indicates the priority of the port to get power in
the event of power over-subscription. Per-port power is enabled
by default. The default priority is low.
Note: Lower numbered ports have precedence over higher numbered
ports of the same priority.
(p. 241)
address.(p. 249)
interface
265