HP ProCurve 5400zl Reference Manual page 223

Command Line Interface Reference Guide
■ interface svlan VLAN-ID connection-rate-filter unblock all
Resets all previously blocked by the connection rate filter
■ interface svlan VLAN-ID monitor all < In | Out | Both >
Monitor all traffic.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
■ Both -- Monitor all inbound and outbound traffic
Next Available Option:
mirror -- Mirror
■
allocate_by
■ interface [ETHERNET] PORT-LIST poe-allocate-by < usage | class | value >
Usage: poe-allocate-by [usage|class|value]
Description: Control manual power over ethernet allocation.
Supported Values:
■ usage
■ class
■ value
any
■ interface vlan VLAN-ID ip pim-dense ip-addr any
Dynamically determine IP address.
■ interface vlan VLAN-ID ip pim-sparse ip-addr any
Dynamically determine IP address.
anycast
■ [no] interface vlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN anycast
Address that is assigned to a set of interfaces that typically belong to different
nodes
■ [no] interface svlan VLAN-ID ipv6 address IPV6-ADDR/PREFIX-LEN anycast
Address that is assigned to a set of interfaces that typically belong to different
nodes
area
■ interface loopback < 0 to 7 > ip ospf IP-ADDR area
© 2009 Hewlett-Packard Development Company, L.P.
destination.(p. 251)
By default, power-over-ethernet allocation is automatic by
usage of the powered device. This can be overriden by manually
specifying how much power this port should be allocated by
either its class or a user-defined value.
interface
221