HP ProCurve 5400zl Reference Manual page 281

Command Line Interface Reference Guide
Next Available Options:
interface
■
vlan -- Enable/disable tracking of VLANs for
■
transit-delay
■ interface vlan VLAN-ID ip ospf transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
■ interface vlan VLAN-ID ip ospf IP-ADDR transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
■ interface vlan VLAN-ID ip ospf all transit-delay < 1 to 3600 >
Set transit delay in seconds; the default is 1.
Range: < 1 to 3600 >
trust
■ [no] interface [ETHERNET] PORT-LIST dhcp-snooping trust
Usage: [no] dhcp-snooping trust PORT-LIST
Description: Configure trusted interfaces. Only server packets received
Parameters:
o PORT-LIST - Port list on which to configure trust status.
■ [no] interface [ETHERNET] PORT-LIST arp-protect trust
ttl-threshold
■ interface vlan VLAN-ID ip pim-dense ttl-threshold < 0 to 255 >
Usage: ip pim-dense ttl-threshold <0-255>
Description: Set the Time To Live in a PIM-DM State Refresh message at
Range: < 0 to 255 >
■ interface vlan VLAN-ID ip mroute ttl-threshold < 0 to 255 >
Usage: ip mroute ttl-threshold <0-255>
Description: Set the multicast datagram TTL threshold for the interface.
Range: < 0 to 255 >
© 2009 Hewlett-Packard Development Company, L.P.
-- Enable/disable tracking of logical ports for
on trusted interfaces will be forwarded. When 'no' is
specified the interfaces are marked as untrusted.
The default port state is untrusted.
which it is not forwarded on this interface. Default is 0.
Any IP multicast datagrams with a TTL less than this threshold
will not be forwarded out the interface. The default value of 0
means all multicast packets are forwarded out the interface.
VR(p. 239)
VR(p. 282)
interface
279