HP ProCurve 5400zl Reference Manual page 493

Command Line Interface Reference Guide
Usage: [no] trap <TRAP-NAME|all>
Description: Enable/disable PIM traps. The traps defined below are generated
Supported Values:
■ neighbor-loss -- A neighbor router was lost.
■ hardware-mrt-full -- Hardware MRT table is full.
■ software-mrt-full -- Software MRT table is full.
■ all -- All types of traps.
traps
■ [no] router vrrp traps
Usage: [no] router vrrp traps
Description: Enable/disable generation of VRRP traps. When 'enabled' an
type
■ [no] router ospf area OSPF-AREA-ID range type < summary | nssa >
Link state database type to apply the range.
Supported Values:
■ summary -- summary.
■ nssa -- nssa.
■ [no] router ospf area backbone range type < summary | nssa >
Link state database type to apply the range.
Supported Values:
■ summary -- summary.
■ nssa -- nssa.
© 2009 Hewlett-Packard Development Company, L.P.
as the result of finding an unusual condition or a timer event.
Possible trap names are:
- 'neighbor-loss' signifies that a neighbor timer expired and the
router has no other neighbors on the same interface with a lower
IP address than itself.
- 'hardware-mrt-full' signifies that the MRT table is full and the
error has been originated by hardware.
- 'software-mrt-full' signifies that the MRT table is full and the
error has been originated by software.
If 'all' is specified in place of a trap name then all the traps
are affected by the command.
appropriate SNMP notification message will be sent as a result
of finding one of the following conditions:
o 'New Master' - this trap indicates that the sending agent
has transitioned to 'Master' state.
o 'Authentication Failure' - this trap indicates that a packet
has been received from a router whose
authentication key or authentication type
conflicts with this router's authentication
key or authentication type.
router
491