HP ProCurve 5400zl Reference Manual page 221

Command Line Interface Reference Guide
ipv6-addr/mask
■
(IPV6-ADDR/PREFIX-LEN)
advert-address
■ interface vlan VLAN-ID ip irdp < multicast | broadcast >
Usage: [no] ip irdp <multicast|broadcast>
Description: Specify the destination address to be used for router
Supported Values:
■ multicast -- Send advertisements to all-hosts multicast address.
■ broadcast -- Send advertisements to broadcast address.
advertise-interval
■ interface vlan VLAN-ID vrrp vrid < 1 to 255 > advertise-interval < 1 to 255 >
Usage: vrrp vrid <VRID> advertise-interval <1-255>
Description: Set time interval (in seconds) between sending VRRP advertisement
Range: < 1 to 255 >
all
■ [no] interface [ETHERNET] PORT-LIST monitor all < In | Out | Both >
Monitor all traffic.
Supported Values:
■ In -- Monitor all inbound traffic
■ Out -- Monitor all outbound traffic
■ Both -- Monitor all inbound and outbound traffic
Next Available Option:
mirror -- Mirror
■
■ [no] interface [ETHERNET] PORT-LIST rate-limit all
Set limits for all traffic.
Next Available Options:
in -- Set limits for all inbound
■
out -- Set limits for all outbound
■
■ [no] interface loopback < 0 to 7 > ip ospf all
© 2009 Hewlett-Packard Development Company, L.P.
-- Configure IPv6 address represented in CIDR notation.
(p. 245)
advertisements.
It has to be either multicast or broadcast. If the value
of this object is 'multicast' (the default), router
advertisements will be sent to the all-hosts multicast
address, 224.0.0.1. If the value of this object is 'broadcast',
router advertisements sent on this interface will be sent to
the limitied broadcast address, 255.255.255.255.
messages. The default value is one second.
destination.(p. 251)
traffic.(p. 238)
traffic.(p. 257)
interface
219