HP ProCurve 5400zl Reference Manual page 285

Command Line Interface Reference Guide
ipv6 -- Configure various IP parameters for the
■
connection-rate-filter
■
blocked by the connection rate
monitor
■
name -- Set the VLAN's name (ASCII-STR)
■
protocol
■
qos -- Set VLAN-based
■
tagged -- Assign ports to current VLAN as tagged ([ethernet] PORT-LIST)
■
untagged
■
forbid -- Prevent ports from becoming a member of the current VLAN ([ethernet] PORT-LIST)
■
(p. 234)
voice -- Labels this VLAN as a Voice VLAN, allowing you to separate, prioritize, and authenticate
■
voice traffic moving through your
jumbo -- Labels this VLAN as a Jumbo VLAN, allowing you to pass packets up to 9220 bytes
■
in size(p. 246)
vrrp -- Enable/disable/configure VRRP operation on the
■
ip-recv-mac-address
■
service-policy
■
■ [no] interface vlan VLAN-ID ipv6 access-group ACCESS-GROUP vlan
VLAN acl.
■ [no] interface vlan VLAN-ID vrrp vrid < 1 to 255 > track vlan
Usage: [no] vrrp vrid <VRID> track vlan <VLAN-ID-RANGE>
Description: Enable/disable tracking of VLANs for VR.
Next Available Option:
vlan-id-range
■
vlan-id-range
■ [no] interface vlan VLAN-ID vrrp vrid < 1 to 255 > track vlan VLAN-ID-RANGE
Usage: [no] vrrp vrid <VRID> track vlan <VLAN-ID-RANGE>
Description: Enable/disable tracking of specified VLANs for VR.
voice
■ [no] interface vlan VLAN-ID voice
Usage: [no] voice
Description: Labels this VLAN as a Voice VLAN, allowing you to separate,
■ [no] interface svlan VLAN-ID voice
© 2009 Hewlett-Packard Development Company, L.P.
-- Re-enables access to a host or set of hosts that has been previously
-- Define either the VLAN is to be monitored or
-- Set a predefined protocol for the current VLAN.
priority(p. 268)
-- Assign ports to current VLAN as untagged ([ethernet] PORT-LIST)
-- Associates a L3-mac-address with a
-- Apply the QoS/Mirror policy on the vlan (ASCII-STR)
Multiple <VLAN-ID-RANGE> can be specified.
-- Enable/disable tracking of specified VLANs for VR (VLAN-ID-RANGE)
prioritize, and authenticate voice traffic moving through
your network.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
VLAN(p. 244)
filter(p. 228)
(p. 254)
network(p. 283)
not(p. 252)
(p. 266)
(p. 278)
VLAN(p. 284)
VLAN(p. 243)
(p. 275)
interface
(p. 282)
(p. 283)
283