HP ProCurve 5400zl Reference Manual page 727

Command Line Interface Reference Guide
Usage: [no] ip forward-protocol udp IP-ADDR PORT-NUM|PORT-NAME
Description: Add or remove a UDP server address for the VLAN. The
Next Available Option:
udp -- Add or remove a UDP server address for the
■
full
■ [no] vlan VLAN-ID ipv6 address dhcp full
Obtain IPv6 address & Configuration information from DHCPv6 server.
Next Available Option:
rapid-commit
■
graft-retry-interval
■ vlan VLAN-ID ip pim-dense graft-retry-interval < 1 to 10 >
Usage: ip pim-dense graft-retry-interval <1-10>
Description: Set the interval a PIM router waits for a Graft Ack before
Range: < 1 to 10 >
hello-delay
■ vlan VLAN-ID ip pim-dense hello-delay < 0 to 5 >
Usage: ip pim-dense hello-delay <0-5>
Description: Set the maximum time before a triggered PIM Hello message is
Range: < 0 to 5 >
■ vlan VLAN-ID ip pim-sparse hello-delay < 0 to 5 >
Usage: ip pim-sparse hello-delay <0-5>
Description: Set the maximum time before a triggered PIM Hello message is
Range: < 0 to 5 >
hello-interval
■ vlan VLAN-ID ip ospf hello-interval < 1 to 65535 >
Set hello interval in seconds; the default is 10.
Range: < 1 to 65535 >
© 2009 Hewlett-Packard Development Company, L.P.
broadcast packets received by the switch on this VLAN are to
be forwarded to the specified application server.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
-- Obtain IPv6 address quickly from DHCPv6
resending a Graft on this interface. Default value is 3
seconds.
transmitted on this interface. Default value is 5 seconds.
transmitted on this interface. Default value is 5 seconds.
VLAN(p. 749)
server.(p. 745)
vlan
725