HP ProCurve 5400zl Reference Manual page 753

Command Line Interface Reference Guide
Usage: [no] voice
Description: Labels this VLAN as a Voice VLAN, allowing you to separate,
vrid
■ [no] vlan VLAN-ID vrrp vrid < 1 to 255 >
Usage: [no] vrrp vrid <VRID> [...]
Description: Configure a virtual router instance for the VLAN.
Range: < 1 to 255 >
Next Available Options:
backup -- Designate the virtual router instance as a
■
owner -- Designate the virtual router instance as an Owner
■
virtual-ip-address
■
primary-ip-address
■
advertisement
advertise-interval
■
advertisement
priority < 1 to 255 > -- Configure priority for the virtual router
■
preempt-mode
■
preempt-delay-time
■
instance(p. 741)
failback
■
failover
■
track -- Enable/disable tracking for
■
enable -- Enable/disable operation of the virtual router
■
vrrp
■ [no] vlan VLAN-ID vrrp
Usage: [no] vlan <VLAN-ID> vrrp vrid <VRID> [...]
Description: Enable/disable/configure VRRP operation on the VLAN.
Next Available Option:
vrid < 1 to 255 > -- Configure a virtual router instance for the
■
© 2009 Hewlett-Packard Development Company, L.P.
prioritize, and authenticate voice traffic moving through
your network.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
A virtual router is defined by its virtual router
identifier (VRID) and a set of IP addresses for which
virtual router acts as a Master or Backup. The scope
of each virtual router is restricted to a single VLAN.
-- Specify IP address to be supported by the virtual router
-- Specify IP address the virtual router instance will use as a source in VRRP
messages(p. 742)
< 1 to 255 > -- Set time interval (in seconds) between sending VRRP
messages(p. 715)
-- Enable/disable preempt mode for the virtual router
< 1 to 600 > -- Enable the pre-emptive delay timer for the virtual router
-- Trigger VR to failback to its configured priority
-- Trigger VR to failover to a
Use 'vrrp vrid <VRID> ?' to get a list of all possible options.
This is a VLAN context command. It can be called directly from
the VLAN context or follow the 'vlan VLAN-ID' command.
Backup(p. 720)
peer(p. 723)
VR(p. 748)
instance(p. 723)
(Master)(p. 739)
instance(p. 750)
instance(p. 742)
instance(p. 742)
value(p. 723)
VLAN(p. 751)
vlan
751