Command Line Interface Reference Guide
Next Available Options:
access-group
■
713)
address
■
proxy-arp
■
local-proxy-arp
■
bootp-gateway
■
requests(p. 720)
helper-address
■
forward-protocol
■
igmp
-- Enable/disable/configure IP Multicast Group Protocol (IGMP) feature on a
■
irdp
-- Configure ICMP Router Discovery Protocol
■
ospf
-- Enable/disable/configure Open Shortest Path First (OSPF) protocol on the VLAN
■
interface(p. 738)
rip
-- Enable/disable/configure Routing Internet Protocol (RIP) on the VLAN
■
pim-dense
■
pim-sparse
■
mroute
-- Configure IP Multicast Routing parameters on the VLAN
■
ip-addr
■ [no] vlan VLAN-ID ip address IP-ADDR/mask-LENGTH
Interface IP address/mask.
■ [no] vlan VLAN-ID ip bootp-gateway IP-ADDR
IPv4 address of the BOOTP gateway.
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR
IP address of the protocol server.
Next Available Options:
port-num
■
port-name
■
■ [no] vlan VLAN-ID ip ospf IP-ADDR
Specify the IP address the request is for.
Next Available Options:
passive
■
area
-- Specify an OSPF
■
authentication-key
■
authentication
■
md5-auth-key-chain
■
cost
< 1 to 65535 > -- Set metric of this
■
dead-interval
■
hello-interval
■
priority
< 0 to 255 > -- Set priority of this router as a designated
■
retransmit-interval
■
transit-delay
■
© 2009 Hewlett-Packard Development Company, L.P.
-- Apply the specified access control list on this VLAN interface (ASCII-STR)
-- Set IP parameters for communication within an IP
-- Enable/disable proxy
-- Enable/disable local proxy
-- Add or remove the gateway address to be used for stamping incoming DHCP
-- Add or remove a DHCP server IP address for the VLAN (IP-ADDR)
-- Add or remove a UDP server address for the
-- Enable/disable/configure PIM-DM protocol on the VLAN
-- Enable/disable/configure PIM-SM protocol on the VLAN
-- UDP port number of the server. (TCP/UDP-PORT)
< dns | ntp | netbios-ns | ... > -- (NUMBER)
-- Configures an ospf interface as passive.
area.(p. 716)
-- Set simple authentication method and
-- Disable
authentication.(p. 717)
-- Set MD5 authentication method and key
< 1 to 65535 > -- Set dead interval in seconds; the default is
< 1 to 65535 > -- Set hello interval in seconds; the default is
< 1 to 3600 > -- Set retransmit interval in seconds; the default is
< 1 to 3600 > -- Set transit delay in seconds; the default is
ARP(p. 744)
ARP(p. 733)
(IRDP)(p. 732)
(p. 741)
(p. 739)
interface.(p. 721)
network(p. 713)
VLAN(p. 724)
VLAN(p. 727)
interface(p. 746)
interface(p. 739)
interface(p. 740)
interface(p. 736)
(p. 741)
key.(p. 717)
chain.(p. 734)
40.(p. 721)
10.(p. 725)
router.(p. 742)
1.(p. 749)
vlan
(p.
(p. 726)
5.(p. 746)
729