Command Line Interface Reference Guide
Next Available Option:
tagvalue
■
only
■ [no] snmpv3 only
Accept only SNMP v3 messages.
params
■ [no] snmpv3 params PARAMS
Configure SNMPv3 Target Parameter entry.
Next Available Option:
user
-- Set user that the switch will send messages on behalf. (ASCII-STR)
■
■ snmpv3 targetaddress TARGETADDRESS params PARAMS
Set parameter name.
Next Available Options:
ipaddr
-- Set IP address of the destination target. (IP-ADDR)
■
ipv6addr
■
port-mask
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IP-ADDR port-mask TCP/UDP-PORT
Set range of udp ports with this mask.
■ snmpv3 targetaddress TARGETADDRESS params PARAMS IPV6-ADDR port-mask TCP/UDP-PORT
Set range of udp ports with this mask.
priv
■ snmpv3 user USERNAME auth AUTHPASSWORD priv
Set Privacy password.
Next Available Options:
privpassword
■
privprotocol
■
■ snmpv3 user USERNAME auth < MD5 | SHA > AUTHPASSWORD priv
Set Privacy password.
Next Available Options:
privpassword
■
privprotocol
■
© 2009 Hewlett-Packard Development Company, L.P.
-- Set tag value that selects entries in the snmpTargetAddr table. (ASCII-STR)
-- Set IPv6 address of the destination target. (IPV6-ADDR)
-- Set Privacy password. (ASCII-STR)
< DES | AES > -- Set privacy protocol.
-- Set Privacy password. (ASCII-STR)
< DES | AES > -- Set privacy protocol.
(p. 627)
(p. 627)
(p. 630)
(p. 630)
(p. 630)
(p. 630)
snmpv3
(p. 632)
(p. 632)
629